28. Two routers named Atlanta and Brevard are connected by their serial interfaces as shown in the exhibit, but there is no data connectivity between them. The Atlanta router is known to have a correct configuration. Given the partial configurations shown in the exhibit, what is the problem on the Brevard router that is causing the lack of connectivity?
A. A loopback is not set.
B. The IP address is incorrect.
C. The subnet mask is incorrect.
D. The serial line encapsulations are incompatible.
E. The maximum transmission unit (MTU) size is too large.
F. The bandwidth setting is incompatible with the connected interface.
B. The IP address is incorrect.
C. The subnet mask is incorrect.
D. The serial line encapsulations are incompatible.
E. The maximum transmission unit (MTU) size is too large.
F. The bandwidth setting is incompatible with the connected interface.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
Prev Next
Correct B
Explaination:
The IP address of the S0 interface of Atlanta is 192.168.10.0/24, and the IP address of the S1 interface of Breavard is 192.168.11.0/24 Change the IP address of the S1 interface to 192.168.10.0/24, the same as that of the S0 interface.
Correct B
Explaination:
The IP address of the S0 interface of Atlanta is 192.168.10.0/24, and the IP address of the S1 interface of Breavard is 192.168.11.0/24 Change the IP address of the S1 interface to 192.168.10.0/24, the same as that of the S0 interface.
No comments:
Post a Comment